Uncategorized – Modeling and Storytelling

Breather

If it got much colder, she was going to need to get serious about starting a fire. The problem was that fire meant smoke. Smoke meant attention and attention meant gunfire. Gunfire meant noise. Noise meant more attention, and so it went. As it was, she’d keep as warm as she could without it. TheContinue reading “Breather”

There Be Tigers

This is a dusty sort of story. It’s about a real place somewhere in Eastern Oregon. It’s true when it needs to be and that’s what matters, dear readers. It has holes in it. What of it? It’s a rendition, rambling and purposeless. It is not a warning. Too late for that. It’s a hypothesis,Continue reading “There Be Tigers”

Completed – An Ancient and Terrible Dice Tower

Welcome back, folks! I’m glad to have this dice tower wrapped up! It provided a lot of challenges and required me to use materials and techniques that were new to me. I’ve put a ton of photos on this post so I’ll just jump right in. Descriptions will follow underneath each photo as a how-to.Continue reading “Completed – An Ancient and Terrible Dice Tower”

Spare Parts Bin

I thought I’d throw together something real quick. It’s been a couple of weeks of hectic work and I missed my self-imposed weekly deadline. I’ve started going back to school for digital media and I’ve spent the last four weeks learning HTML and CSS. It’s changed quite a bit since I last did it inContinue reading “Spare Parts Bin”

Go West, Young Man

“Go West, young man, go West. There is health in the country, and room away from our crowds of idlers and imbeciles.” “That,” I said, “is very frank advice, but it is medicine easier given than taken. It is a wide country, but I do not know just where to go.” “It is all roomContinue reading “Go West, Young Man”

Designing and Printing the Fantastic Robo-Jarv Part 3

I finally got the body to print. I had another print failure since the last post before figuring out what the problem was. Long story short, I had to change the FEP film in the resin vat. That’s a story for another day, though. I cleaned the uncured resin from the body and snipped offContinue reading “Designing and Printing the Fantastic Robo-Jarv Part 3”